Wind turbine gearbox lubricating oil filtration system
Summary:The gears inside the gearbox will inevitably wear out and produce
Keywords:
Hydraulic Offline filtering
Category:
Description
Compact and simple structure: The main components (two types of filters and temperature control valve) are assembled on the mounting bracket, integrated and hung on the side of the gearbox (as shown in the figure below);

Function: The gears inside the gearbox will inevitably wear out and produce iron sludge during long-term operation, so it is necessary to continuously clean and filter them.
Explanation of the main working principle of the system:
The magnetic core and fiberglass filtration systems work in parallel and cycle, respectively filtering metal iron powder, non-metallic impurities, and moisture; When the amount of impurities adsorbed by the fiberglass filter reaches a certain level, an alarm will be triggered. When the blockage is severe, the oil will be merged into the magnetic filter system through a merging check valve with a pressure of 4 bar;
The magnetic filtration system is designed with a temperature control valve, which gradually opens the channel when the oil temperature is greater than 45 ℃, and the gear oil partially flows through the cooler (built-in in the gearbox); When the oil temperature exceeds 60 ℃, the channel will be fully opened, and the gear oil will completely flow through the cooler for heat dissipation;
The main pump is a large displacement, low-noise internal meshing helical gear pump suitable for high viscosity lubrication systems in the wind power industry;
Affected by the viscosity temperature characteristics of gear oil, the motor operation is controlled by a temperature sensor: gear oil has a high viscosity below 5 ℃, and the motor pump does not start; When the temperature is ≥ 5 ℃, the motor pump operates at low speed and low power output; When the temperature is ≥ 30 ℃, the motor pump operates at high speed and high power output.
Other products